INCLUDE
   
PARAMETERS: <name of file>
Starts processing the content of given file. The search of file will be performed in the current directory, all search paths (see option -I). For every path the content of samples, headers, traces folders will be also examined. You can also type just the name of file without INCLUDE
   
PARAMETERS: <name of file>
Starts processing the content of given file. The search of file will be performed in the current directory, all search paths (see option -I). For every path the content of samples, headers, traces folders will be also examined. You can also type just the name of file without INCLUDE
   
PARAMETERS: <name of file>
Starts processing the content of given file. The search of file will be performed in the current directory, all search paths (see option -I). For every path the content of samples, headers, traces folders will be also examined. You can also type just the name of file without include before it.

 before it.

 before it.

 ethernet2  
// inserted into standart Ethernet II header
INCLUDE
   
PARAMETERS: <name of file>
Starts processing the content of given file. The search of file will be performed in the current directory, all search paths (see option -I). For every path the content of samples, headers, traces folders will be also examined. You can also type just the name of file without INCLUDE
   
PARAMETERS: <name of file>
Starts processing the content of given file. The search of file will be performed in the current directory, all search paths (see option -I). For every path the content of samples, headers, traces folders will be also examined. You can also type just the name of file without INCLUDE
   
PARAMETERS: <name of file>
Starts processing the content of given file. The search of file will be performed in the current directory, all search paths (see option -I). For every path the content of samples, headers, traces folders will be also examined. You can also type just the name of file without include before it.

 before it.

 before it.

 ipv6_header

CLEARMASK
   
PARAMETERS: no parameters
The mask of packet (the set of previously defined conditions) will be cleared. New mask will correspond to any packet. This command is usually contained in headers to make the mask correspond to all packets of given type (ex: TCP packets).



ethproto = ip6
POS
   
PARAMETERS: <new position> | <field's name>
Sets the <new position> of byte pointer. In the case of <field's name> new position will be equal to field's position.

 ip6.dst
PASS
   
PARAMETERS: <number of bytes>
Increases the byte pointer for the given <number of bytes>.

 16

//ip6.src 0:0:0:b0:0:0cc:d00:0
//PRINT
   
PARAMETERS: <message>
Displays the given message. Use symbol 
 in message to indicate that line feed must be performed.

 
'$ip6.src$'
\n'